Serv-Clip® Type 1
Pipe measuring point Serv-Clip® Type 1 (for mounting on pressurized pipes)
Hydraulic Pipe measuring point Serv-Clip® Type 1 (for mounting on pressurized pipes) with 1/4" screw for hydraulic and gear oils
Installation in only 3 minutes - no cutting pipelines- Installation with jaw/screw wrench only
How it works?
A needle is pressed through the wall of the steel or stainless steel pipe. It uses the principle of plastic deformation to create a leak-proof opening.
Hydraulic pipe measuring point Serv-Clip® Type 1 (for mounting on pressurized pipes)
This is what you can do instantaneously:
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Quick and cheap installation (only 3 minutes)
Measurement without switching off
No need to cut tubes
No cleaning necessary
No contamination of fluids
- For installation on steel and stainless steel pipes
- For diameters:
from 10 - 42 mm /Tube 3/8" - 2" / Pipe ¼" to 3"
- Working pressure up to 630 bar (9100 psi)
- Working temperature from -40°C to +120 °C
- Viton O-Ring in leak proof clamp (200°C) incl 1/4"screw and valve M16x2