Serv-Clip® Type 2
Pipe measuring point Serv-Clip® Type 2 (for mounting on non-pressurized pipes)
Hydraulic Pipe measuring point Serv-Clip® Type 2 (for mounting on non-pressurized pipes) with 3/8"screw
For hydraulic and gear oils
Installation of Sensors in few minutes - no cutting pipelines- Installation with jaw/screw wrench only
How it works?
A needle is pressed through the wall of the steel or stainless steel pipe. It uses the principle of plastic deformation to create a leak-proof opening. Finally you remove the needle and stirrup to measure.
Hydraulic pipe measuring point Serv-Clip® Type 2 (for mounting on non-pressurized pipes)
This is what you can do instantaneously:
Measure pressure
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Installation with our sensors and others with G 3/8":
Flow rate
Leakage
Temperature
Pressure
Aqua
Advantages!
Quick and low-cost installation (only 3 minutes)
Minimal downtime
No need to cut tubes
No cleaning necessary
No competition in the market!
No contamination
- For installation on steel and stainless steel pipelines
- For Diameters:
from 10 - 42 mm/ Tube 3/8"- 2"/ Pipe ¼" to 3" - Working pressure up to 630 bar (9100 psi)
- Working temperature from -40°C to +120 °C
- Viton O-Ring in leak proof clamp (200°C)
- Incl 3/8" screw and valve M16x2